Technician Focus - Barrie Stilgoe
Barrie started with Farol in 2013 having previously trained as a motor car mechanic and trained
to NQV Level 3. He continued in this trade and progressed to be a diagnostic technician. Since
joining Barrie has shown that his talent for troubleshooting and diagnosis has been put to good
use as he has come up to speed with to sophistication and technology on today’s John Deere
product. Barrie can turn his hand to just about anything however he is often found working on
the more complex tractors and combines. Barrie is an avid model aircraft enthusiast and is often
at the controls of one of his selection of jet turbines..
I enjoy the technology and the sophistication of the modern John Deere machines.
Since working for Farol I have had great training and development and enjoy the
challenges of getting a customer going.
- Barrie Stilgoe, Farol Technician
Engine Top End Tune
Front Linkage Fitting
Fuel System Clean
Note: Fitted price does not
include supply of linkage.
Fixed price for front linkage
fitting in depot on
6010/6020/6030/6R and 6M
Make sure your engine is
performing at it’s full power and
efficiency by having the valve
*00/10/20/30 Series tractors at
your nearest Farol Depot.
Chemical clean of the fuel system
to remove deposits which build
up over time, keeping your valves
and injectors in top condition.
*When booked with a fixed
price service, normally £350.
The tractor Expect Check consists of a 49 point
John Deere approved inspection where any
controller codes are retrieved, examined and
cleared; followed by an engine software update
is one is available.
The brake system will be bled, nitrogen
accumulators on cab/axle suspension checked
and recharged if needed,
front axle tracking checked and fuel
tank treated. This is then concluded by a performance test on our
mobile dynamometer and a follow-up report with advice on any
further work or optimisation your tractor may benefit from.